StudioCalcs

Recording and export

Audio file size calculator: WAV, AIFF and bit depth

Find out how big an uncompressed recording will be from its length, sample rate, bit depth and channel count, before you hit export.

Audio file size calculator

Live

Uncompressed file size

—

Duration

—

Size in MB

—

Per minute

—

Size in GB

—

These numbers are exact for WAV, AIFF and BWF, which store audio without compression. MP3 and AAC will be smaller by whatever the encoder and bitrate save.

How to use the audio file size calculator

Enter the length of the recording, choose the sample rate, the bit depth and whether the file is mono or stereo. The big number is the size in megabytes; the boxes below show the duration, the size per minute and the same figure in gigabytes once a file gets large.

A minute of 44.1 kHz, 16-bit stereo audio is about 10.1 MB. The same minute at 48 kHz and 24-bit stereo is about 16.5 MB, so a five minute song that was 50 MB in the old session is closer to 83 MB in the new one. That difference is exactly why so many hard drives fill up after a switch to higher resolution.

Why the numbers are exact for WAV and AIFF

WAV, AIFF and BWF store every sample without compression. The size depends only on three things: how many samples per second (the sample rate), how many bits each sample uses (the bit depth), and how many channels you record.

Size in bytes = seconds x sample rate x bit depth / 8 x channels

That is the whole formula, which is why the calculator can be trusted for uncompressed audio and why it cannot be trusted for MP3 or AAC. A compressed file depends on the encoder, the bitrate and even the content: silence compresses to almost nothing while a dense mix compresses poorly.

Bit depth versus sample rate

People mix these two up constantly. The sample rate sets the highest frequency you can capture: 44.1 kHz reaches about 22 kHz, which covers everything a person can hear. The bit depth sets the dynamic range, roughly 96 dB at 16-bit and 144 dB at 24-bit. Doubling the sample rate doubles the file size; going from 16-bit to 24-bit increases it by half again. If you need to save space, dropping from 96 kHz to 48 kHz halves the file with almost no audible cost for most material.

Where this is useful in practice

  • Planning a session before recording: two hours of multitrack at 96 kHz and 24-bit takes serious drive space.
  • Checking whether a long ambient render will fit on a USB stick or an upload limit.
  • Deciding whether to keep stems at full resolution or bounce a lower rate for sharing.
  • Estimating download sizes for a sample pack or a client delivery.

One thing to remember

Most DAWs report file sizes using decimal megabytes (1 MB = 1,000,000 bytes) while operating systems often report binary megabytes (1 MiB = 1,048,576 bytes). The difference is under five percent, so a file that the calculator calls 100 MB may show up as 95 MB in a file manager. Neither number is wrong.

Related calculators

Delay and reverb work in milliseconds rather than megabytes, so if you are setting up an effect chain, start with the delay time calculator and the reverb time calculator.