StudioCalcs

Reverb and room acoustics

Reverb time calculator: estimate RT60 from room size

Enter the dimensions of a room and the kind of surfaces in it, and get an RT60 estimate before you open a single reverb preset.

Reverb time calculator (RT60)

Live

Estimated reverb time (RT60)

—

Room volume

—

Total surface

—

RT60

—

Absorption used

—

What RT60 actually measures

RT60 is the time it takes for a sound to decay by 60 decibels after the source stops. It is the single number acousticians use to compare rooms, and it is why a cathedral and a vocal booth feel like different planets even when they are mixed with the same reverb plugin.

Measure the length, the width and the ceiling height of the room, pick the surface that describes most of what the sound hits, and the calculator returns an RT60 estimate. Switch between metres and feet with the unit selector; the result is always in seconds.

The formula behind it

The calculator uses the Sabine equation, which is the standard estimate for a diffuse sound field:

RT60 = 0.161 x volume / (total surface area x average absorption)

Volume and surface area come from your three dimensions. Absorption is a coefficient between 0 and 1: bare concrete reflects almost everything and sits near 0.05, while a room covered in absorber panels can reach 0.6 or higher. Real rooms are a mix of surfaces, so pick the value that matches the majority of the walls, floor and ceiling. If half the room is carpet and half is drywall, expect the real number to land somewhere between the two coefficients.

Rough targets worth knowing

  • Under 0.2 seconds: a dead booth, good for close-miked vocals, difficult for drums.
  • 0.25 to 0.4 seconds: a treated control room or a small studio live room.
  • 0.5 to 0.7 seconds: a live room, flattering for drums and guitars.
  • 0.8 to 1.2 seconds: a small hall, too long for tracking but useful for ambience.
  • Above 1.5 seconds: a church or a large hall, essentially a reverb you cannot remove.

Why your room will differ from the number

The Sabine equation assumes the air in the room is moving in a diffuse field and that every surface has one absorption value. Neither is true in a bedroom studio with a mattress in one corner. Expect the real decay to differ by twenty percent or more, and expect low frequencies to decay slower than the mid range, which is why bass builds up in small rooms even when the RT60 looks reasonable.

Use the estimate to choose a starting point: if the calculation says half a second, a plate or a room plugin will feel natural and a five-second hall will fight the performance. Then trust your ears and a reference track.

Related calculators

If you are setting a pre-delay to go with that reverb, the delay time calculator gives you a tempo-locked value in milliseconds. To check how much disk space a long ambient render takes, use the audio file size calculator.